Goto Section: 15.235 | 15.237 | Table of Contents

FCC 15.236
Revised as of October 1, 2016
Goto Year:2015 | 2017
  § 15.236   Operation of wireless microphones in the bands 54-72 MHz, 76-88
MHz, 174-216 MHz, 470-608 MHz and 614-698 MHz.

   (a) Definitions. The following definitions apply in this section.

   (1) Wireless Microphone. An intentional radiator that converts sound
   into electrical audio signals that are transmitted using radio signals
   to a receiver which converts the radio signals back into audio signals
   that are sent through a sound recording or amplifying system. Wireless
   microphones may be used for cue and control communications and
   synchronization of TV camera signals as defined in § 74.801 of this
   chapter. Wireless microphones do not include auditory assistance
   devices as defined in § 15.3(a) of this part.

   (2) 600 MHz duplex gap. An 11 megahertz guard band that separates part
   27 600 MHz service uplink and downlink frequencies, in accordance with
   the terms and conditions established in GN Docket No. 12-268, pursuant
   to section 6403 of the Spectrum Act.

   (3) 600 MHz guard bands. Designated frequency bands that prevent
   interference between licensed services in the 600 MHz service band and
   either the television bands or channel 37, in accordance with the terms
   and conditions established in GN Docket No. 12-268, pursuant to section
   6403 of the Spectrum Act.

   (4) 600 MHz service band. Frequencies that will be reallocated and
   assigned for 600 MHz services pursuant to part 27, in accordance with
   the terms and conditions established in GN Docket No. 12-268, pursuant
   to section 6403 of the Spectrum Act.

   Note to paragraphs (a)(2), (3) and (4): The specific frequencies will
   be determined in light of further proceedings pursuant to GN Docket No.
   12-268 and the rules will be updated accordingly pursuant to a future
   public notice.

   (5) Spectrum Act. Title VI of the Middle Class Tax Relief and Job
   Creation Act of 2012 (Pub. L. 112-96).

   (b) Operation under this section is limited to wireless microphones as
   defined in this section.

   (c) Operation is permitted in the following frequency bands.

   (1) Channels allocated and assigned for the broadcast television
   service. The highest channel available will depend on the outcome of
   the incentive auction.

   (2) Frequencies in the 600 MHz service band on which a 600 MHz service
   licensee has not commenced operations, as defined in § 27.4 of this
   chapter. Operation on these frequencies must cease no later than the
   end of the post-auction transition period, as defined in § 27.4 of this
   chapter. Operation must cease immediately if harmful interference
   occurs to a 600 MHz service licensee.

   (3) The upper six megahertz segment of the 600 MHz duplex gap.

   (4) The 600 MHz guard band between television and 600 MHz service
   downlink services, excluding the upper one megahertz segment.

   (5) The 600 MHz guard bands adjacent to channel 37, excluding the one
   megahertz segments furthest from channel 37.

   (6) Prior to operation in the frequencies identified in paragraphs
   (c)(2) through (5) of this section, wireless microphone users shall
   rely on the white space databases in part 15, Subpart H to determine
   that their intended operating frequencies are available for unlicensed
   wireless microphone operation at the location where they will be used.
   Wireless microphone users must register with and check a white space
   database to determine available channels prior to beginning operation
   at a given location. A user must re-check the database for available
   channels if it moves to another location.

   (d) The maximum radiated power shall not exceed the following values:

   (1) In the bands allocated and assigned for broadcast television and in
   the 600 MHz service band: 50 mW EIRP

   (2) In the 600 MHz guard bands including the duplex gap: 20 mW EIRP

   (e) Operation is limited to locations separated from licensed services
   by the following distances.

   (1) Four kilometers outside the following protected service contours of
   co-channel TV stations.
   Type of station Protected contour
   Channel Contour
   (dBu) Propagation curve
   Analog: Class A TV, LPTV, translator and booster Low VHF (2-6) 47
   F(50,50)
       High VHF (7-13) 56 F(50,50)
       UHF (14-51) 64 F(50,50)
   Digital: Full service TV, Class A TV, LPTV, translator and booster Low
   VHF (2-6) 28 F(50,90)
       High VHF (7-13) 36 F(50,90)
       UHF (14-51) 41 F(50,90)

   (2) The following distances outside of the area where a 600 MHz service
   licensee has commenced operations, as defined in § 27.4 of this chapter.
           Type of station Separation distance in kilometers
   Co-
   channel Adjacent
   channel
           Base              7                          0.2
           Mobile           35                           31

   (f) The operating frequency within a permissible band of operation as
   defined in paragraph (c) must comply with the following requirements.

   (1) The frequency selection shall be offset from the upper or lower
   band limits by 25 kHz or an integral multiple thereof.

   (2) One or more adjacent 25 kHz segments within the assignable
   frequencies may be combined to form a channel whose maximum bandwidth
   shall not exceed 200 kHz. The operating bandwidth shall not exceed 200
   kHz.

   (3) The frequency tolerance of the carrier signal shall be maintained
   within ±0.005% of the operating frequency over a temperature variation
   of −20 degrees to +50 degrees C at normal supply voltage, and for a
   variation in the primary supply voltage from 85% to 115% of the rated
   supply voltage at a temperature of 20 degrees C. Battery operated
   equipment shall be tested using a new battery.

   (g) Emissions within the band from one megahertz below to one megahertz
   above the carrier frequency shall comply with the emission mask in
   Section 8.3 of ETSI EN 300 422-1 V1.4.2 (2011-08) (incorporated by
   reference, see § 15.38). Emissions outside this band shall comply with
   the limit specified at the edges of the ETSI mask.

   [ 80 FR 73069 , Nov. 23, 2015, as amended at  81 FR 4974 , Jan. 29, 2016]

   return arrow Back to Top


Goto Section: 15.235 | 15.237

Goto Year: 2015 | 2017
CiteFind - See documents on FCC website that cite this rule

Want to support this service?
Thanks!

Report errors in this rule. Since these rules are converted to HTML by machine, it's possible errors have been made. Please help us improve these rules by clicking the Report FCC Rule Errors link to report an error.
hallikainen.com
Helping make public information public