Goto Section: 15.213 | 15.215 | Table of Contents

FCC 15.214
Revised as of October 2, 2015
Goto Year:2014 | 2016
§ 15.214   Cordless telephones.

   (a) For equipment authorization, a single application form, FCC Form 731,
   may be filed for a cordless telephone system, provided the application
   clearly identifies and provides data for all parts of the system to show
   compliance  with  the applicable technical requirements. When a single
   application  form is submitted, both the base station and the portable
   handset must carry the same FCC identifier. The application shall include a
   fee for certification of each type of transmitter and for certification, if
   appropriate, for each type of receiver included in the system.

   (b) A cordless telephone that is intended to be connected to the public
   switched telephone network shall also comply with the applicable regulations
   in part 68 of this chapter. A separate procedure for approval under part 68
   is required for such terminal equipment.

   (c) The label required under subpart A of this part shall also contain the
   following statement: “Privacy of communications may not be ensured when
   using this phone.”

   (d) Cordless telephones shall incorporate circuitry which makes use of a
   digital security code to provide protection against unintentional access to
   the public switched telephone network by the base unit and unintentional
   ringing by the handset. These functions shall operate such that each access
   of  the telephone network or ringing of the handset is preceded by the
   transmission of a code word. Access to the telephone network shall occur
   only if the code transmitted by the handset matches code set in the base
   unit.  Similarly,  ringing of the handset shall occur only if the code
   transmitted  by the base unit matches the code set in the handset. The
   security code required by this section may also be employed to perform other
   communications functions, such as providing telephone billing information.
   This security code system is to operate in accordance with the following
   provisions.

   (1) There must be provision for at least 256 possible discrete digital
   codes. Factory-set codes must be continuously varied over at least 256
   possible codes as each telephone is manufactured. The codes may be varied
   either randomly, sequentially, or using another systematic procedure.

   (2) Manufacturers must use one of the following approaches for facilitating
   variation in the geographic distribution of individual security codes:

   (i) Provide a means for the user to readily select from among at least 256
   possible discrete digital codes. The cordless telephone shall be either in a
   non-operable mode after manufacture until the user selects a security code
   or the manufacturer must continuously vary the initial security code as each
   telephone is produced.

   (ii) Provide a fixed code that is continuously varied among at least 256
   discrete digital codes as each telephone is manufactured.

   (iii) Provide a means for the cordless telephone to automatically select a
   different code from among at least 256 possible discrete digital codes each
   time it is activated.

   (iv) It is permissible to provide combinations of fixed, automatic, and
   user-selectable coding provided the above criteria are met.

   (3) A statement of the means and procedures used to achieve the required
   protection shall be provided in any application for equipment authorization
   of a cordless telephone.

   [ 56 FR 3785 , Jan. 31, 1991, as amended at  63 FR 36603 , July 7, 1998;  66 FR 7580 , Jan. 24, 2001]

   return arrow Back to Top

Radiated Emission Limits, Additional Provisions

   return arrow Back to Top


Goto Section: 15.213 | 15.215

Goto Year: 2014 | 2016
CiteFind - See documents on FCC website that cite this rule

Want to support this service?
Thanks!

Report errors in this rule. Since these rules are converted to HTML by machine, it's possible errors have been made. Please help us improve these rules by clicking the Report FCC Rule Errors link to report an error.
hallikainen.com
Helping make public information public