Goto Section: 80.213 | 80.217 | Table of Contents

FCC 80.215
Revised as of October 1, 2014
Goto Year:2013 | 2015
§ 80.215   Transmitter power.

   (a) Transmitter power shown on the radio station authorization is the
   maximum power the licensee is authorized to use. Power is expressed in
   the following terms:

   (1) For single sideband emission: Peak evelope power;

   (2) For G3E emission: Carrier power;

   (3) For PON and F3N emission: Mean power;

   (4) For all emissions in the 1626.5-1646.5 MHz band: equivalent
   isotropic radiated power.

   (5) For all other emissions: the carrier power multiplied by 1.67.

   (b) Coast station frequencies below 27500 kHz. The maximum power must
   not exceed the values listed below.

   (1) Public coast stations, except Alaska:

   (i) Radiotelegraphy:

   100-160 kHz--80kW

   405-525 kHz--40kW

   2035-2065 kHz--6.6kW

   4000-8000 kHz--10kW

   8000-9000 kHz--20kW

   12000-27500 kHz--30kW

   (ii) Radiotelephony:

   2000-4000 kHz--day--800W

   2000-4000 kHz--night--400W

   4000-27500 kHz--10kW

   (2) Private coast stations, except in Alaska: 1kW

   (3) Coast stations in Alaska, public and private:

   405-525 kHz--265W

   1605-12000 kHz--150W

   (c) Coast station frequencies above 27500 kHz. The maximum power must
   not exceed the values listed below.

   (1) Coast stations:

   156-162 MHz-50W1 2 13

   1Maximum authorized power at the input terminals of the station
   antenna.

   216-220 MHz2

   2See paragraph (h) of this section.

   (2) Marine utility stations:

   156-162 MHz--10W

   (d) Ship station frequencies below 27500 kHz. The maximum power must
   not exceed the values listed below:

   (1) Radiotelegraphy: All ships--2kW3

   3For passenger ships 5000 gross tons and over--8kW. For cable-repair
   ships operating on radiodetermination frequencies, 15 watts; see
   § 80.375(b).

   (2) Radiotelephony:

   (i) All ships--Great Lakes and Inland Waters--150W

   (ii) All ships--Open waters; 2000-4000 kHz--150W

   2182 kHz--emergency, urgency, or safety ship to shore--400W4

   4For passenger ships 5000 gross tons and over--1kW.

   (iii) All ships--Open waters; 4000-27500 kHz--1.5kW5.

   5For passenger ships 5,000 gross tons and over 3kW.

   (3) Digital selective calling:

   All ships 415-526.5 kHz--400 W

   All ships 1605-4000 kHz--400 W

   All ships 4000-27500 kHz--1.5 kW

   (e) Ship stations frequencies above 27500 kHz. The maximum power must
   not exceed the values listed below.

   (1) Ship stations 156-162 MHz--25W6 13

   6Reducible to 1 watt or less, except for transmitters limited to public
   correspondence channels and used in an automated system.

   13The frequencies 156.775 and 156.825 MHz are available for
   navigation-related port operations or ship movement only, and all
   precautions must be taken to avoid harmful interference to channel 16.
   Transmitter output power is limited to 1 watt for ship stations, and 10
   watts for coast stations.

   Marine utility stations and hand-held portable transmitters: 156-162
   MHz-10W

   (2) Ship stations 216-220 MHz--25W7

   7[Reserved]

   (3) On board stations 456-468 MHz--4W8

   8Certification based on a carrier power of 4 watts with transmitter
   connected to a dummy load of matching impedance. The effective radiated
   power must not exceed 2 watts.

   (4) Ship earth stations 1626.5-1646.5 MHz9

   9See paragraph (k) of this section.

   (5) Ship radar stations with F3N emission--200 mW

   (6) EPIRB--121.500 and 243.00 MHz10

   10See subpart V of this part.

   (7) EPIRB--156.750 and 156.800 MHz10

   (f) Fixed stations. The maximum power must not exceed the values+
   listed below.

   (1) Maritime support (receiver test):

   R3E and J3C emission--150W

   F3E emission--50W

   (2) Operational fixed: 72-76 MHz and above 162 MHz11

   11See paragraph (l) of this section.

   (3) Alaska--Private fixed:12

   12The frequencies 156.375 MHz and 156.650 MHz are primarily intership
   frequencies. When authorized for coast stations on a secondary basis,
   the normal output power must not exceed 1 watt and the maximum output
   power must not exceed 10 watts.

   10-200 kHz--650W

   405-525 kHz--265W

   1605-12000 kHz--150W

   (4) Alaska--Public fixed:

   405-525 kHz--1kW

   1605-12000 kHz--1kW

   (g) The carrier power of ship station radiotelephone transmitters,
   except portable transmitters, operating in the 156-162 MHz band must be
   at least 8 but not more than 25 watts. Transmitters that use 12 volt
   lead acid storage batteries as a primary power source must be measured
   with a primary voltage between 12.2 and 13.7 volts DC. Additionally,
   unless otherwise indicated, equipment in radiotelephone ship stations
   operating in the 156-162 MHz band must meet the following requirements:

   (1) All transmitters and remote control units must be capable of
   reducing the carrier power to one watt or less;

   (2) Except as indicated in (g)(4) of this section, all transmitters
   manufactured after January 21, 1987, or in use after January 21, 1997,
   must automatically reduce the carrier power to one watt or less when
   the transmitter is tuned to 156.375 MHz or 156.650 MHz, and must be
   provided with a manual override switch which when held by an operator
   will permit full carrier power operation on 156.375 MHz and 156.650
   MHz;

   (3) Except as indicated in (g)(4) of this section, all ship station
   transmitters installed after January 9, 2006, must be capable of tuning
   to 156.775 MHz and 156.825 MHz and must automatically reduce the
   carrier power to one watt or less, with no manual override capability,
   when the transmitter is tuned to either 156.775 MHz or 156.825 MHz;

   (4) Hand-held portable transmitters are not required to comply with the
   automatic reduction of carrier power in (g)(2) of this section; and

   (5) Transmitters dedicated for use on public correspondence duplex
   channels as additional equipment to a VHF ship station in the Great
   Lakes which meet all pertinent rules in this part are not required to
   reduce their carrier power to one watt.

   (h) Coast stations in an AMTS may radiate as follows, subject to the
   condition that no harmful interference will be caused to television
   reception except that TV services authorized subsequent to the filing
   of the AMTS station application will not be protected.

   (1) When located more than 169 kilometers (105 miles) from the antenna
   of a Channel 13 TV station and more than 129 kilometers (80 miles) from
   the antenna of a channel 10 station, the ERP of coast stations having
   an antenna height of 61 meters (200 feet) or less above ground must not
   exceed 1000 watts.

   (2) Coast stations located less than 169 kilometers (105 miles) from a
   channel 13 TV station, or less than 129 kilometers (80 miles) from a
   channel 10 TV station, or when using a transmitting antenna height
   above ground greater than 61 meters (200 feet), must submit a plan to
   limit interference to TV reception, unless the station's predicted
   interference contour is fully encompassed by the composite interference
   contour of the system's existing stations, or the station's predicted
   interference contour extends the system's composite interference
   contour over water only (disregarding uninhabited islands). The plan
   must include:

   (i) A description of the interference contour with indentification of
   the method used to determine this contour; and

   (ii) A statement concerning the number of residences within the
   interference contour. The interference contour includes only areas
   inside the TV grade B contour with the latter determined assuming
   maximum permissible TV antenna height and power for broadcast stations
   and the actual facility parameters for translators and low power TV
   stations. See part 73, subpart E of this chapter for further
   information on TV grade B contour determination.

   (3) When located as described in paragraph (h)(2) of this section, the
   coast station (or stations affecting the same TV Grade B contour) will
   be authorized if the applicant's plan has limited the interference
   contour(s) to fewer than 100 residences or if the applicant:

   (i) Shows that the proposed site is the only suitable location (which,
   at the application stage, requires a showing that the proposed site is
   especially well-suited to provide the proposed service);

   (ii) Develops a plan to control any interference caused to TV reception
   within the Grade B contour from its operations; and

   (iii) Agrees to make such adjustments in the TV receivers affected as
   may be necessary to eliminate interference caused by its operations.

   (4) The applicant must eliminate any interference caused by its
   operation to TV reception within the Grade B contour that might develop
   within 90 days of the time it is notified in writing by the Commission.
   If this interference is not removed within the 90-day period, operation
   of the coast station must be discontinued. The licensee is expected to
   help resolve all complaints of interference, whether inside or outside
   the Grade B contour.

   (5) The transmitter power, as measured at the input terminals to the
   station antenna, must be 50 watts or less.

   (i) A ship station must have a transmitter output not exceeding 25
   watts and an ERP not exceeding 18 watts. The maximum transmitter output
   power is permitted to be increased to 50 watts under the following
   conditions:

   (1) Increases exceeding 25 watts are made only by radio command from
   the controlling coast stations; and

   (2) The application for an equipment authorization demonstrates that
   the transmitter output power is 25 watts or less when external radio
   commands are not present.

   (j) A ship installation with a transmitter output power exceeding 25
   watts under the conditions of paragraph (i) of this section is exempted
   from the limitation of 18 watts ERP when operating in specific
   geographical areas identified in a plan for the use of higher power.

   (k) Within the 1626.5-1646.5 MHz band the maximum e.i.r.p by a ship
   earth station in any direction in the horizontal plane or in the
   direction of the space station must not exceed +40 dB relative to one
   watt in any 4 kHz band in the main beam, except upon a satisfactory
   showing of need for greater power, in which case a maximum of +55 dB
   relative to one watt may be authorized.

   (l) For operational fixed stations using frequencies in the 72-76 MHz
   band and for other classes of stations operating above 162.025 MHz, the
   transmitter power must be specified in the station authorization.
   Frequencies in the 72-76 MHz band are listed in § 80.381. The
   operational requirements for 72-76 MHz are contained in subpart L of
   this part.

   (m) For radiodetermination transmitters using A1D, A2D, F1D, F2D, G1D
   and G2D emissions on 154.585 MHz, 159.480 MHz, 160.725 MHz, 160.785
   MHz, 454.000 MHz and 459.000 MHz the mean output power of the
   unmodulated carrier must not exceed 25 watts.

   (n) For radiodetermination stations operating above 2400 MHz the output
   power must be as follows:

   (1) For radar stations that use F3N emission the mean output power must
   not exceed 200 milliwatts;

   (2) For search and rescue stations the output power must be at least
   400 milliwatts peak e.i.r.p.

   (3) For all other transponder stations the output power must not exceed
   20 watts peak e.i.r.p. Licensees of non-selectable transponder coast
   stations operating in the 2920-3100 MHz and 9320-9500 MHz bands must
   notify in writing the USCG District Commander of any incremental
   increase of their station's output power above 5 watts peak e.i.r.p.

   [ 51 FR 31213 , Sept. 2, 1986, as amended at  52 FR 7419 , Mar. 11, 1987;
    52 FR 35244 , Sept. 18, 1987;  54 FR 40058 , Sept. 29, 1989;  54 FR 49994 ,
   Dec. 4, 1989;  56 FR 3783 , Jan. 31, 1991;  59 FR 35269 , July 11, 1994;  63 FR 36606 , July 7, 1998;  65 FR 77824 , Dec. 13, 2000;  67 FR 48564 , July
   25, 2002;  68 FR 46965 , Aug. 7, 2003;  69 FR 64673 , Nov. 8, 2004]

   return arrow Back to Top


Goto Section: 80.213 | 80.217

Goto Year: 2013 | 2015
CiteFind - See documents on FCC website that cite this rule

Want to support this service?
Thanks!

Report errors in this rule. Since these rules are converted to HTML by machine, it's possible errors have been made. Please help us improve these rules by clicking the Report FCC Rule Errors link to report an error.
hallikainen.com
Helping make public information public